Brake
On-vehicle inspection
In this manual: Brake
8steps
~48min
2/5difficulty
Done 0 of 8
1. INSPECT BRAKE BOOSTER

(a) Airtightness check.
- Start the engine and stop it after 1 or 2 minutes. Depress the brake pedal several times slowly.
HINT: If the pedal can be depressed (to the floor) the first time, but cannot be depressed as far on the 2nd or 3rd time, the booster is airtight.
- Depress the brake pedal while the engine is running, and stop the engine with the pedal depressed.
HINT: If there is no change in the pedal reserve distance while holding the pedal for 30 seconds, the booster is airtight.

(b) Operating check.
- Depress the brake pedal several times with the ignition switch off and check that there is no change in the pedal reserve distance.
- Start the engine with the brake pedal depressed.
HINT: If the pedal goes down slightly, operation is normal.
2. INSPECT VACUUM CHECK VALVE
(a) Check vacuum check valve.
- Slide the clip and disconnect the vacuum hose.
- Remove the vacuum check valve.

- Check that there is ventilation from the booster to engine, and no ventilation from the engine to the booster.
- If any fault is found, replace the vacuum check valve.
COMPONENTS

Was this page helpful?