Installation

• Use the same procedures for the lh side and rh side.
• The procedures listed below are for the lh side.
• A bolt without a torque specification is shown in the standard bolt chart (see page ss-2).

1. Install front shoulder belt anchor adjuster assembly

1. Align the adjuster positioning hole with the claw, and install the adjuster with the 2 bolts as shown in the illustration.

2. Install front shoulder belt anchor plate sub-assembly lh

1. Install the plate as shown in the illustration.

Make sure the plate is firmly set into the garnish's claws.

3. Install front seat outer belt assembly lh

Do not disassemble the retractor.

1. Align the 2 claws with the seat belt positioning holes, and install the retractor of the outer belt with the bolt as shown in the illustration.

   Torque: 8.5 N*m (87 kgf*cm, 75 in.*Lbf)

2. Connect the pretensioner connector as shown in the illustration.

1. 1
   Connect the outer belt with the shoulder anchor's bolt.

   Torque: 42 n*m (428 kgf*cm, 31 ft.*Lbf)

2. 2
   Install center pillar garnish lh

   

1. 1
   Pass the outer belt anchor through the center pillar garnish.
2. 2
   Attach the clip.
3. 3
   Install the garnish with the 2 screws.
4. 4
   Install center pillar garnish lower lh

   

1. 1
   Attach the 2 claws and 2 clips to install the garnish.
2. 2
   Connect the floor anchor with the bolt.

   Torque: 42 n*m (428 kgf*cm, 31 ft.*Lbf)

3. 3
   Attach the lap belt outer anchor cover
4. 4
   Install rear door opening trim weatherstrip lh
5. 5
   Install rear door scuff plate lh (see page ir-57)
6. 6
   Install front door scuff plate lh (see page ir-59)
7. 7
   Install front door opening trim weatherstrip lh
8. 8
   Connect cable to negative battery terminal