Removal

• Use the same procedures for the lh side and rh side.
• The procedures listed below are for the lh side.

1. Disconnect cable from negative battery terminal

1. 1
   Remove front door scuff plate lh (see page ir-26)
2. 2
   Remove front door opening trim weatherstrip lh
3. 3
   Remove rear door scuff plate lh (see page ir-29)
4. 4
   Remove rear door opening trim weatherstrip lh
5. 5
   Remove center pillar garnish lower lh

   

1. 1
   Remove the lap belt anchor cover.
2. 2
   Remove the anchor's built-in bolt from the pillar and disconnect the outer belt.

   

3. Using a screwdriver, detach the 2 claws.

Tape the screwdriver tip before use.

1. 1
   Using a clip remover, detach the 2 clips and remove the garnish.
2. 2
   Remove center pillar garnish lh

   

1. 1
   Using a screwdriver, remove the 2 screws.
2. 2
   Using a clip remover, detach the clip then remove the garnish.
3. 3
   Pull out the outer belt anchor from the center pillar garnish.
4. 4
   Remove front seat outer belt assembly lh

   

1. Remove the nut and disconnect the shoulder anchor.

2. Disconnect the pretensioner connector as shown in the illustration.

1. 1
   Remove the bolt and outer belt.
2. 2
   Remove front shoulder belt anchor plate sub-assembly lh

   

1. 1
   Using a screwdriver, detach the 6 claws.
2. 2
   Remove the anchor plate from the garnish.

Tape the screwdriver tip before use.

10. Remove front shoulder belt anchor adjuster assembly

1. Remove the 2 bolts and anchor.