Installation

1. Install tire pressure warning antenna and receiver

1. Install the receiver with the bolt.

Torque: 7.5 N*m (76 kgf*cm, 66 in.*Lbf)

Connect the connector.

1. 1
   Install inner roof side garnish assembly rh (see page ir-52)
2. 2
   Install deck trim side panel assembly rh (w/o rear no. 2 Seat) (see page ir-53)
3. 3
   install deck trim side panel assembly rh (w/ rear no. 2 seat) (see page ir-54)
4. 4
   Install tether anchor bracket subassembly (w/o rear no. 2 Seat) (see page ir-54)
5. 5
   Install reclining remote control lever bezel rh (w/o rear no. 2 Seat) (see page se-105)
6. 6
   Install rear deck trim cover rh (w/ rear no.

2 Seat) (see page ir-55)

Install rear floor finish plate (see page ir- 55)

Install rear floor no. 1 Mat support side plate (see page ir-55)

Install rear floor no. 2 Board

Install rear floor no. 3 Board

Install rear no. 2 Seat assembly lh (w/ rear no. 2 Seat) (see page se-121)

Install rear no. 2 Seat assembly rh (w/ rear no. 2 Seat) (see page ir-55)

Install no. 2 Seat leg cover lh (w/ rear no. 2 Seat) (see page se-123)

Install no. 2 Seat leg cover rh (w/ rear no. 2 Seat) (see page ir-56)

Install no. 2 Seat hinge cover lh (w/ rear no.

2 Seat) (see page se-123)

Install no. 2 Seat hinge cover rh (w/ rear no.

2 Seat) (see page ir-56)

Install deck board assembly (w/o rear no. 2 Seat)

Install rear floor no. 1 Board (w/o rear no.

2 Seat)

Install tonneau cover assembly (w/o rear no. 2 Seat)

Install package tray tirm pocket subassembly (w/o rear no. 2 Seat)

Install rear door scuff plate rh (see page ir-57)

Connect cable to negative battery terminal

Register transmitter id (see page tw-10)

Inspect tire pressure warning system