Removal

1. Disconnect cable from negative battery terminal

Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

1. 1
   Remove rear door scuff plate rh (see page ir-29)
2. 2
   Remove package tray trim pocket subassembly (w/o rear no. 2 Seat)
3. 3
   Remove tonneau cover assembly (w/o rear no. 2 Seat)
4. 4
   Remove rear floor no. 1 Board (w/o rear no.

2 Seat)

Remove deck board assembly (w/o rear no. 2 Seat)

Remove no. 2 Seat hinge cover lh (w/ rear no.

2 Seat) (see page se-109)

Remove no. 2 Seat hinge cover rh (w/ rear no.

2 Seat) (see page ir-30)

Remove no. 2 Seat leg cover lh (w/ rear no. 2 Seat) (see page se-109)

Remove no. 2 Seat leg cover rh (w/ rear no. 2 Seat) (see page ir-30)

Remove rear no. 2 Seat assembly lh (w/ rear no. 2 Seat) (see page se-110)

Remove rear no. 2 Seat assembly rh (w/ rear no. 2 Seat) (see page ir-30)

Remove rear floor no. 3 Board

Remove rear floor no. 2 Board

Remove rear floor no. 1 Mat support side plate (see page ir-31)

Remove rear floor finish plate (see page ir- 31)

Remove rear deck trim cover rh (w/ rear no.

2 Seat) (see page ir-31)

Remove reclining remote control lever bezel rh (w/o rear no. 2 Seat) (see page se-80)

Remove tether anchor bracket subassembly (w/o rear no. 2 Seat) (see page ir-32)

Remove deck trim side panel assembly rh (w/o rear no. 2 Seat) (see page ir-33)

Remove deck trim side panel assembly rh (w/ rear no. 2 Seat) (see page ir-34)

Remove inner roof side garnish assembly rh (see page ir-35)

Remove tire pressure warning antenna and receiver

1. 1
   Disconnect the connector.
2. 2
   Remove the bolt and receiver.