Toyota RAV4 Quiz
Tire and wheel

Tc and cg terminal circuit

In this manual: Tire and wheel
Introduction — 37Interior — 12Exterior — 432Az-fe engine mechanical — 1552Az-fe ignition — 182Az-fe charging — 232Az-fe emission control — 82az-fe exhaust — 32Az-fe fuel — 72Az-fe lubrication — 4Brake — 17Brake control — 63U140f automatic transaxle — 59Instrument panel — 8Suspension — 18Drive shaft — 23Axle — 6Tire and wheel — 30Air conditioning — 93Lighting — 45Cruise control — 21Differential — 12Door lock — 31Engine immobiliser — 21Horn — 5Can communication — 27Mirror — 5Parking brake — 5Power steering — 27Propeller shaft — 3Seat — 29Seat belt — 27Sliding roof — 25Steering column — 6Wiper and washer — 11Supplemental restraint system — 95Other system — 5Maintenance — 14
3steps
~18min
2/5difficulty
Done 0 of 3
Description

Dtc output mode is set by connecting terminals 13 (tc) and 4 (cg) of the dlc3. The dtcs are indicated by the blinking of the tire pressure warning light.

Wiring diagram
Toyota RAV4. Tc and cg terminal circuit

Hint:

When each warning light continues blinking, a ground short in the wiring of terminal tc of the dlc3 or an internal ground short in each ecu may have occurred.

Inspection procedure Notice:

It is necessary to register an id code after replacing the tire pressure monitor valve and/or the tire pressure warning ecu (see page tw-9).

  1. Check wire harness (dlc3 - ecu)
Toyota RAV4. Check wire harness (dlc3 - ecu)

  1. Disconnect the e13 dlc3 connector.
  2. Disconnect the e56 ecu connector.
  3. Measure the resistance of the wire harness side connectors.
Standard resistance


Proceed to next circuit inspection shown in problem symptoms table

Test yourself

A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.