Toyota Sienna Quiz
Mirror

Position Sensor Circuit

In this manual: Mirror
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
7steps
~42min
2/5difficulty
Done 0 of 7

DESCRIPTION

When SET and 1 or 2 are pressed, the position sensor detects the mirror position and sends the signal to the outer mirror control ECU. Then when position 1 or 2 is pressed, the outer mirror control ECU drives the mirror motor based on the memorized sensor positions.

HINT: The power mirror control system is part of the multiplex communication system. This system features shared communication wiring that reduces the wiring complexity of the communication lines. The first step in any repair is to confirm the proper operation of the communication system. Proceed with troubleshooting after the communication has been verified (See Multiplex Communication System)

WIRING DIAGRAM

WIRING DIAGRAM

INSPECTION PROCEDURE

1 READ VALUE OF INTELLIGENT TESTER

  1. Connect the intelligent tester to the DLC3.
  2. Ignition switch on.
  3. Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DATA LIST.
  4. Read the DATA LIST according to the display on the tester.

MIRROR-L/MIRROR-R

MIRROR-L/MIRROR-R

OK: Tester displayed is 0 V to 5 V.

2 CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR - OUTER MIRROR CONTROL ECU)

CHECK HARNESS AND CONNECTOR
  1. Disconnect the O10 or O12 ECU connector.
  2. Disconnect the O13 or O14 outer mirror connector.
  3. Measure the resistance according to the value(s) in the table below.

Resistance

Resistance

*1: LH side
*2: RH side

REPLACE OUTER MIRROR CONTROL ECU

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.