Toyota Sienna Quiz
Seat

Reclining Motor Circuit

In this manual: Seat
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
7steps
~42min
2/5difficulty
Done 0 of 7

DESCRIPTION

The fold seat control ECU receives a switch operation signal from the power rear no. 2 seat switch and the fold seat switch, and activates the reclining motor. At this time, the Hall IC (seatback position sensor) detects the actuation of the seatback and sends a seatback actuation signal to the fold seat control ECU.

The fold seat control ECU uses signals from the Hall IC (seatback position sensor) to detect if an object is caught or if any other abnormal condition has occurred.

WIRING DIAGRAM

WIRING DIAGRAM

INSPECTION PROCEDURE

1 INSPECT FOLD SEAT CONTROL ECU

INSPECT FOLD SEAT CONTROL ECU
  1. Remove the fold seat control ECU with connectors still connected.
  2. Measure the voltage according to the value(s) in the table below.

Standard voltage: LH side

Standard voltage

RH side

Standard voltage

2 CHECK HARNESS AND CONNECTOR (FOLD SEAT CONTROL ECU - RECLINING MOTOR)

CHECK HARNESS AND CONNECTOR
  1. Disconnect the connectors from the fold seat control ECU.
    CHECK HARNESS AND CONNECTOR
  2. Disconnect the connectors from the reclining motor.
  3. Measure the resistance according to the value(s) in the table below.

Standard resistance: LH side

Standard resistance

RH side

Standard resistance
Standard resistance

3 INSPECT RECLINING MOTOR

INSPECT RECLINING MOTOR
  1. Check reclining motor operation.
  2. Check if the motor rotates smoothly when the battery is connected to the reclining motor.

OK: LH side

OK

RH side

OK

REPLACE FOLD SEAT CONTROL ECU

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.