Seat

Folding Motor Circuit

5steps
~30min
2/5difficulty
Done 0 of 5

DESCRIPTION

The fold seat control ECU receives a switch operation signal from the fold seat switch and activates the folding motor. At this time, the Hall IC (seat cushion position sensor) detects the actuation signal. The fold seat control ECU uses signals from the Hall IC (seat cushion position sensor) to detect if an object if an object is caught or if any other abnormal condition has occurred.

WIRING DIAGRAM

WIRING DIAGRAM

INSPECTION PROCEDURE

1 INSPECT FOLD SEAT CONTROL ECU

INSPECT FOLD SEAT CONTROL ECU
  1. Remove the fold seat control ECU.
  2. Measure the voltage according to the value(s) in the table below.

Standard voltage: LH side

Standard voltage

RH side

Standard voltage

2 CHECK HARNESS AND CONNECTOR (FOLD SEAT CONTROL ECU - FOLDING MOTOR)

CHECK HARNESS AND CONNECTOR
  1. Disconnect the connector from the fold seat control ECU.
  2. Disconnect the connector from the fold seat motor.
  3. Measure the resistance according to the value(s) in the table below.

Standard resistance: LH side

Standard resistance

RH side

Standard resistance

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.