Rear Power Seat Switch Circuit

DESCRIPTION

When the power rear no. 2 seat switch is operated, a recline signal is sent to the fold seat control ECU.

The ECU activates the reclining motor based on the signal from the power rear no. 2 seat switch.

WIRING DIAGRAM

INSPECTION PROCEDURE

1 INSPECT FOLD SEAT CONTROL ECU

1. 1
   Remove the fold seat control ECU.
2. 2
   Measure the voltage according to the value(s) in the table below.

Standard voltage: LH side

RH side

2 CHECK HARNESS AND CONNECTOR (FOLD SEAT CONTROL ECU - FOLDING MOTOR)

1. 1
   Disconnect the connectors from the fold seat control ECU.
2. 2
   Disconnect the connector from the folding motor.
3. 3
   Measure the resistance according to the value(s) in the table below.

Standard resistance: LH side

RH side

3 INSPECT POWER REAR NO. 2 SEAT SWITCH

1. 1
   Disconnect the connector from the power rear no. 2 seat switch.
2. 2
   Measure the resistance according to the value(s) in the table below.

Standard resistance: LH side

RH side

4 CHECK HARNESS AND CONNECTOR (FOLDING MOTOR - BODY GROUND)

1. Measure the resistance according to the value(s) in the table below.

Standard resistance: LH side

RH side

5 REPAIR OR REPLACE HARNESS OR CONNECTOR (WIRE INSIDE SEAT)

1. Repair or replace harness or connector (wire inside seat) and check that the malfunction disappears.

OK: Malfunction disappears.

END