Brake control
TS and CG Terminal Circuit
In this manual: Brake control
~1min read
DESCRIPTION
The Test Mode (signal check) circuit detects trouble in the sensor or switch signal, which cannot be detected by the DTC check.
Connecting terminals TS and CG of the DLC3 starts the check.
WIRING DIAGRAM

INSPECTION PROCEDURE
1 CHECK HARNESS AND CONNECTOR (BETWEEN SKID CONTROL ECU AND TS of DLC3)

(a) Turn the ignition switch off.
(b) Disconnect the skid control ECU connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance 


2 CHECK HARNESS AND CONNECTOR (BETWEEN CG of DLC3 AND BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.
Standard resistance


3 CHECK HARNESS AND CONNECTOR (BETWEEN TS of DLC3 AND BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.
Standard resistance 


REPLACE BRAKE ACTUATOR ASSEMBLY
Test yourself
A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?