Cruise control
Vehicle Speed Sensor Malfunction
In this manual: Cruise control
~1min read
DTC P0500 Vehicle Speed Sensor Malfunction
DTC P0503 Vehicle Speed Sensor "A" Intermittent / Erratic / High
DESCRIPTION The cruise control system uses the same vehicle speed signal that is sent to the ECM for the SFI system.
If DTC P0500 is detected, perform the diagnosis using the inspection procedure for DTC P0500 in the SFI system. The speed signal is converted for use by the cruise control inside the ECM.
Both the SFI system and the cruise control system can set DTC P0500, however the detection conditions of the two systems are different.
DTC No. |
DTC Detection Condition |
Trouble Area |
P0500 |
The vehicle speed signal from the vehicle speed sensor is cut for 0.14 sec. or more while cruise control is in operation |
|
P0503 |
Momentary interruption and noise are detected when a rapid change of vehicle speed occurs while cruise control is in operation |
|
WIRING DIAGRAM
Refer to DTC P0500
INSPECTION PROCEDURE
Refer to DTC P0500
Test yourself
A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?