Toyota Tacoma Quiz
Cruise Control

Cruise Control Input Circuit (P0575)

In this manual: Cruise Control
Introduction — 15Maintenance — 8Audio / Video — 94Garage Door Opener — 7Navigation / Multi Info Display — 84Park Assist / Monitoring — 86Brake — 50Brake Control / Dynamic Control Systems — 165Parking Brake — 52gr-fks Charging — 252gr-fks Cooling — 212gr-fks Emission Control — 132gr-fks Engine Control — 322gr-fks Engine Mechanical — 332gr-fks Exhaust — 92gr-fks Fuel — 422gr-fks Ignition — 62gr-fks Intake — 72gr-fks Lubrication — 152gr-fks Starting — 38Ac60e Automatic Transmission / Transaxle — 146Axle — 19Clutch — 20Cruise Control — 168Differential — 50Drive Shaft — 6Propeller Shaft — 23Rc62f Manual Transmission / Transaxle — 34Suspension — 22Tire And Wheel — 39Vf2cm Transfer — 44Can Communication — 45Multiplex Communication — 20Power Distribution — 5Power Steering — 29Steering Column — 29Air Conditioning — 108Door Lock — 88Engine Hood / Door — 16Engine Immobiliser — 47Exterior — 55Horn — 5Interior — 18Interior Panel — 8Lighting — 93Meter / Gauge / Display — 31Mirror — 22Other System — 24Pre-collision — 40Seat — 52Seat Belt — 40Sliding Roof — 26Supplemental Restraint Systems — 139Theft Deterrent — 20Window / Glass — 53Wiper / Washer — 24
3steps
~18min
2/5difficulty
Done 0 of 3
DESCRIPTION

This DTC is stored when there is a malfunction in the ECM.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

P0575

Cruise Control Input Circuit

Either of the following conditions is met:

  • When the ignition switch is ON, STP signals received by the ECM supervisory CPU and that received by the control ECU do not match for approximately 0.2 seconds or more.
  • While the dynamic radar cruise control system is operating, the dynamic radar cruise control system control of vehicle speed is not canceled and approximately 0.4 seconds have elapsed after cruise cancel signal (STP signal) is received by the ECM.

ECM
CAUTION / NOTICE / HINT

NOTICE:

Before replacing the ECM, refer to Registration.

w/o Smart Key System: Click here w/ Smart Key System: Click here

w/ Smart Key System: Click here HINT:

HINT:

The ECM receives signals from each sensor to control all functions of the cruise control system. When a malfunction is detected, the fail-safe function operates until the ignition switch off.

PROCEDURE

  1. CHECK FOR DTCs (RADAR CRUISE1)

(a) Clear the DTCs.

Click here (b) Perform the following to make sure that the DTC detection conditions are

(b) Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.

  1. Drive the vehicle at a speed for which dynamic radar cruise control operation is possible.
  2. Turn the cruise control system on using the cruise control main switch (ON-OFF button).
  3. Depress the brake pedal for 0.4 seconds or more.

(c) Check for DTCs.

Click here

Result

Proceed to

DTC P0575 are not output.

A

DTC P0575 are output.

B
A

USE SIMULATION METHOD TO CHECK
B

REPLACE ECM

Test yourself

A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.