Cruise Control System Internal Failure (P057504,P057549)
This DTC is stored when there is a malfunction in the ECM.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL |
|---|---|---|---|---|
P057504 |
Cruise Control System Internal Failure |
While the dynamic radar cruise control system is operating, the dynamic radar cruise control system control of vehicle speed is not canceled and approximately 0.4 seconds have elapsed after cruise cancel signal (STP signal) is received by the ECM. |
ECM |
Does not come on |
P057549 |
Cruise Control Internal Electronic Failure |
While the dynamic radar cruise control system is operating, STP signals received by the ECM supervisory CPU and that received by the control ECU do not match for approximately 0.2 seconds or more. |
ECM |
Does not come on |
NOTICE:
Before replacing the ECM, refer to Registration.
w/o Smart Key System: Click here .gif)
w/ Smart Key System: Click here .gif)
HINT:
The ECM receives signals from each sensor to control all functions of the cruise control system. When a malfunction is detected, the fail-safe function operates until the ignition switch is turned off.
PROCEDURECHECK FOR DTCs
(a) Clear the DTCs.
Click here .gif)
(b) Perform the following procedure.
HINT:
If the following procedure is not performed, the previously output DTC cannot be detected.
- Drive the vehicle at a speed for which dynamic radar cruise control operation is possible.
- Turn the dynamic radar cruise control system on using the cruise control main switch.
- Depress the brake pedal for 1 second or more.
(c) Check for DTCs.
Click here .gif)
OK:
DTC P057504 and P057549 are not output.
| OK | ![]() |
USE SIMULATION METHOD TO CHECK |
| NG | ![]() |
REPLACE ECM |
Test yourself
A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.
.gif)