Toyota Tacoma Quiz
Air Conditioning

Disassembly

In this manual: Air Conditioning
Introduction — 15Maintenance — 8Audio / Video — 94Garage Door Opener — 7Navigation / Multi Info Display — 84Park Assist / Monitoring — 86Brake — 50Brake Control / Dynamic Control Systems — 165Parking Brake — 52gr-fks Charging — 252gr-fks Cooling — 212gr-fks Emission Control — 132gr-fks Engine Control — 322gr-fks Engine Mechanical — 332gr-fks Exhaust — 92gr-fks Fuel — 422gr-fks Ignition — 62gr-fks Intake — 72gr-fks Lubrication — 152gr-fks Starting — 38Ac60e Automatic Transmission / Transaxle — 146Axle — 19Clutch — 20Cruise Control — 168Differential — 50Drive Shaft — 6Propeller Shaft — 23Rc62f Manual Transmission / Transaxle — 34Suspension — 22Tire And Wheel — 39Vf2cm Transfer — 44Can Communication — 45Multiplex Communication — 20Power Distribution — 5Power Steering — 29Steering Column — 29Air Conditioning — 108Door Lock — 88Engine Hood / Door — 16Engine Immobiliser — 47Exterior — 55Horn — 5Interior — 18Interior Panel — 8Lighting — 93Meter / Gauge / Display — 31Mirror — 22Other System — 24Pre-collision — 40Seat — 52Seat Belt — 40Sliding Roof — 26Supplemental Restraint Systems — 139Theft Deterrent — 20Window / Glass — 53Wiper / Washer — 24
~1min read
1special tools
DISASSEMBLY PROCEDURE

1. REMOVE PRESSURE RELIEF VALVE

(a) Remove the pressure relief valve and O-ring.

(a) Remove the pressure relief valve and O-ring.

2. REMOVE MAGNET CLUTCH ASSEMBLY

(a) Secure the cooler compressor assembly in a vise between aluminum plates.

(a) Secure the cooler compressor assembly in a vise between aluminum plates.

(b) Using SST, hold the magnet clutch hub.

SST: 09985-00260

(c) Remove the bolt, magnet clutch hub and compressor spacer.

HINT:

There is no set number of magnet clutch washers since they are used for adjusting.

(d) Using a snap ring expander, remove the snap ring and magnet clutch rotor.

NOTICE:

Do not damage the seal cover of the bearing when removing the snap ring.

(e) Remove the screw.

(f) Disconnect the connector.

(g) Using a snap ring expander, remove the snap ring and magnet clutch stator.

3. REMOVE COMPRESSOR PICK UP SENSOR

(a) Disengage the clamp.

(b) Remove the 3 screws and compressor pick up sensor.

Test yourself

A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.