Inspection

1. INSPECT MAGNET CLUTCH ASSEMBLY

(a) Inspect the magnet clutch assembly. Text in Illustration *a Component without harness connected (Magnet Clutch Assembly)

(b) Confirm that the magnet clutch hub and magnet clutch rotor lock when the battery positive lead is connected to terminal 1 (MG+) of the magnet clutch, and the negative lead is connected to the ground wire.

If the result is not as specified, replace the magnet clutch assembly.

2. INSPECT A/C LOCK SENSOR

(a) Measure the resistance according to the value(s) in the table below. Text in Illustration *a Component without harness connected (A/C LOCK SENSOR) Standard Resistance: Tester Connection Condition Specified Condition 2 (SSR+) - 3 (SSR-) 20°(68°F) 160 to 320 Ω If the resistance is not as specified, replace the cooler compressor assembly.