How To Proceed With Troubleshooting
HINT:
Use these procedures to troubleshoot the rear view monitor system.
PROCEDUREVEHICLE BROUGHT TO WORKSHOP
|
CUSTOMER PROBLEM ANALYSIS
|
CHECK DTC
(a) Check for DTCs and note any codes that are output.
Click here .gif)
(b) Clear the DTCs.
Click here .gif)
(c) Recheck for DTCs.
Result | Proceed to |
|---|---|
DTC is not output |
A |
DTC is output |
B |
| B | ![]() |
GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
PROBLEM SYMPTOM CONFIRMATION
|
PROBLEM SYMPTOMS TABLE
(a) Refer to Problem Symptoms Table.
Click here
.gif)
Result | Proceed to |
|---|---|
Fault is not listed in Problem Symptoms Table |
A |
Fault is listed in Problem Symptoms Table |
B |
| B | ![]() |
GO TO STEP 7 |
|
BASED ON PROBLEM SYMPTOM, PERFORM TROUBLESHOOTING BELOW
(a) Terminals of ECU.
Click here .gif)
|
ADJUST, REPAIR OR REPLACE
|
CONFIRMATION TEST
| NEXT | ![]() |
END |
Test yourself
A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.
.gif)
.gif)