Toyota Tacoma Quiz
Other System

Rear Power Outlet Switch

In this manual: Other System
Introduction — 15Maintenance — 8Audio / Video — 94Garage Door Opener — 7Navigation / Multi Info Display — 84Park Assist / Monitoring — 86Brake — 50Brake Control / Dynamic Control Systems — 165Parking Brake — 52gr-fks Charging — 252gr-fks Cooling — 212gr-fks Emission Control — 132gr-fks Engine Control — 322gr-fks Engine Mechanical — 332gr-fks Exhaust — 92gr-fks Fuel — 422gr-fks Ignition — 62gr-fks Intake — 72gr-fks Lubrication — 152gr-fks Starting — 38Ac60e Automatic Transmission / Transaxle — 146Axle — 19Clutch — 20Cruise Control — 168Differential — 50Drive Shaft — 6Propeller Shaft — 23Rc62f Manual Transmission / Transaxle — 34Suspension — 22Tire And Wheel — 39Vf2cm Transfer — 44Can Communication — 45Multiplex Communication — 20Power Distribution — 5Power Steering — 29Steering Column — 29Air Conditioning — 108Door Lock — 88Engine Hood / Door — 16Engine Immobiliser — 47Exterior — 55Horn — 5Interior — 18Interior Panel — 8Lighting — 93Meter / Gauge / Display — 31Mirror — 22Other System — 24Pre-collision — 40Seat — 52Seat Belt — 40Sliding Roof — 26Supplemental Restraint Systems — 139Theft Deterrent — 20Window / Glass — 53Wiper / Washer — 24
~1min read
Components COMPONENTS ILLUSTRATION Inspection Inspection INSPECTION PROCEDURE

1. INSPECT MAIN SWITCH ASSEMBLY

(a) Check the main switch assembly.

(1) Measure the resistance according to the value(s) in the table below.

Text in Illustration

*a

Component without harness connected

(Main Switch Assembly)

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

6 (IG) - 3 (E)

Switch on

Below 1 Ω

Switch off

10 kΩ or higher
  • If the specified condition is not met, replace the main switch assembly.

(b) Check the switch indicator.

(1) Apply battery voltage to the main switch assembly and check that the switch indicator illuminates.

OK:

Measurement Condition

Switch Condition

Specified Condition

Battery positive (+) → 5 (IND+)

Battery positive (-) → 2 (IND-)

Always

Illuminates

OK:

Measurement Condition

Switch Condition

Specified Condition

Battery positive (+) → 6 (IG)

Battery positive (-) → 4 (IND)

Always

Illuminates
  • If the specified condition is not met, replace the main switch assembly.
Removal REMOVAL PROCEDURE

1. REMOVE INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY RH

(See page ) ) )

2. REMOVE MAIN SWITCH ASSEMBLY

(a) Disengage the 2 claws to remove the main switch assembly.
Installation INSTALLATION PROCEDURE

1. INSTALL MAIN SWITCH ASSEMBLY

(a) Engage the 2 claws to install the main switch assembly.

2. INSTALL INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY RH

(See page ) ) )

Test yourself

A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.