Toyota Tacoma Quiz
2gr-fks Fuel

Reassembly

In this manual: 2gr-fks Fuel
Introduction — 15Maintenance — 8Audio / Video — 94Garage Door Opener — 7Navigation / Multi Info Display — 84Park Assist / Monitoring — 86Brake — 50Brake Control / Dynamic Control Systems — 165Parking Brake — 52gr-fks Charging — 252gr-fks Cooling — 212gr-fks Emission Control — 132gr-fks Engine Control — 322gr-fks Engine Mechanical — 332gr-fks Exhaust — 92gr-fks Fuel — 422gr-fks Ignition — 62gr-fks Intake — 72gr-fks Lubrication — 152gr-fks Starting — 38Ac60e Automatic Transmission / Transaxle — 146Axle — 19Clutch — 20Cruise Control — 168Differential — 50Drive Shaft — 6Propeller Shaft — 23Rc62f Manual Transmission / Transaxle — 34Suspension — 22Tire And Wheel — 39Vf2cm Transfer — 44Can Communication — 45Multiplex Communication — 20Power Distribution — 5Power Steering — 29Steering Column — 29Air Conditioning — 108Door Lock — 88Engine Hood / Door — 16Engine Immobiliser — 47Exterior — 55Horn — 5Interior — 18Interior Panel — 8Lighting — 93Meter / Gauge / Display — 31Mirror — 22Other System — 24Pre-collision — 40Seat — 52Seat Belt — 40Sliding Roof — 26Supplemental Restraint Systems — 139Theft Deterrent — 20Window / Glass — 53Wiper / Washer — 24
~2min read
REASSEMBLY CAUTION / NOTICE / HINT

NOTICE:

Do not try to remove the black nylon tube as it is welded to the fuel suction tube assembly (See page ). HINT: ).

HINT:

Perform "Inspection After Repairs" after replacing the fuel pump (See page PROCEDURE ).

PROCEDURE

1. INSTALL FUEL PUMP

HINT:

Perform "Inspection After Repairs" after replacing the fuel pump (See page ).

(a) Apply a light coat of gasoline to a new O-ring. Then install the fuel pump spacer and O-ring to the fuel pump.

Text in Illustration

*1

O-ring

*2

Fuel Pump Spacer

(b) Connect the fuel pump harness connector and install the fuel pump harness to the fuel pump.

(c) Install the fuel pump to the fuel filter case.

NOTICE:

Make sure that the O-ring is not cut or pinched during the installation.

(d) Engage the 2 claws and install the No. 1 fuel suction support to the fuel filter case.

(e) Engage the clamp and connect the wire harness.

2. INSTALL FUEL PUMP FILTER

(a) Engage the claw and connect the fuel pump harness to the fuel pump filter.

(b) Engage the 3 claws and install the fuel pump filter to the fuel filter case.

3. INSTALL NO. 1 FUEL SUB-TANK

(a) Engage the 5 claws and install the No. 1 fuel sub-tank.

(b) While aligning with the installation position of the No. 1 fuel sub-tank, install the jet pump.

(c) Engage the 2 clamps and claw and connect the jet pump nozzle to the No. 1 fuel sub-tank.

(d) Engage the clamp and connect the wire harness.

(e) Connect the 2 fuel pump connectors.

4. INSTALL FUEL SENDER GAUGE ASSEMBLY

Fuel Pump Ecu

Test yourself

A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.