Toyota Tacoma Quiz
Brake Control / Dynamic Control Systems

Traction Off Switch

In this manual: Brake Control / Dynamic Control Systems
Introduction — 15Maintenance — 8Audio / Video — 94Garage Door Opener — 7Navigation / Multi Info Display — 84Park Assist / Monitoring — 86Brake — 50Brake Control / Dynamic Control Systems — 165Parking Brake — 52gr-fks Charging — 252gr-fks Cooling — 212gr-fks Emission Control — 132gr-fks Engine Control — 322gr-fks Engine Mechanical — 332gr-fks Exhaust — 92gr-fks Fuel — 422gr-fks Ignition — 62gr-fks Intake — 72gr-fks Lubrication — 152gr-fks Starting — 38Ac60e Automatic Transmission / Transaxle — 146Axle — 19Clutch — 20Cruise Control — 168Differential — 50Drive Shaft — 6Propeller Shaft — 23Rc62f Manual Transmission / Transaxle — 34Suspension — 22Tire And Wheel — 39Vf2cm Transfer — 44Can Communication — 45Multiplex Communication — 20Power Distribution — 5Power Steering — 29Steering Column — 29Air Conditioning — 108Door Lock — 88Engine Hood / Door — 16Engine Immobiliser — 47Exterior — 55Horn — 5Interior — 18Interior Panel — 8Lighting — 93Meter / Gauge / Display — 31Mirror — 22Other System — 24Pre-collision — 40Seat — 52Seat Belt — 40Sliding Roof — 26Supplemental Restraint Systems — 139Theft Deterrent — 20Window / Glass — 53Wiper / Washer — 24
~1min read
Components COMPONENTS ILLUSTRATION Removal Removal REMOVAL PROCEDURE

1. REMOVE ROOF CONSOLE BOX ASSEMBLY

(See page 2. REMOVE A-TRAC SWITCH (TRACTION CONTROL SWITCH) )

2. REMOVE A-TRAC SWITCH (TRACTION CONTROL SWITCH)

(a) Disconnect the A-TRAC switch (traction control switch) connector.

(b) Using a screwdriver, detach the 2 claws and remove the A-TRAC switch (traction control switch) from the roof console box assembly.
Inspection INSPECTION PROCEDURE

1. INSPECT A-TRAC SWITCH (TRACTION CONTROL SWITCH)

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Text in Illustration

*a

Component without harness connected

(A-TRAC Switch (Traction Control Switch))

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

5 - 8

Pressed

Below 1 Ω

Not pressed

10 kΩ or higher

If the value is not as specified, replace the A-TRAC switch (traction control switch).
Installation INSTALLATION PROCEDURE

1. INSTALL A-TRAC SWITCH (TRACTION CONTROL SWITCH)

(a) Attach the 2 claws to install the A-TRAC switch (traction control switch) into the roof console box assembly.

(b) Connect the A-TRAC switch (traction control switch) connector.

2. INSTALL ROOF CONSOLE BOX ASSEMBLY

(See page Vehicle Stability Control System(for Hydraulic Brake Booster) )

Test yourself

A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.