Front Speed Sensor

1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

3. REMOVE FRONT WHEEL

4. REMOVE FRONT SPEED SENSOR

(a) Disconnect the speed sensor connector.

(b) Remove the bolt and front speed sensor.

NOTICE:

• Do not attach any foreign matter to the sensor tip.
• Ensure that no foreign matter enters the sensor installation part.

1. INSTALL FRONT SPEED SENSOR

(a) Install the front speed sensor with the bolt.

Torque:

8,3 N·m {85 kgf·cm, 73 in·lbf}

NOTICE:

Make sure that the sensor tip is clean.

(b) Connect the speed sensor connector.

2. INSTALL FRONT WHEEL

Torque:

113 N·m {1152 kgf·cm, 83 ft·lbf}

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:

5,4 N·m {55 kgf·cm, 48 in·lbf}

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

4. CHECK VSC SENSOR SIGNAL (for Hydraulic Brake Booster)

Click here

5. CHECK VSC SENSOR SIGNAL (for Vacuum Brake Booster)

Click here