Vsc Off Switch

1. INSPECT VSC OFF SWITCH

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below. Text in Illustration *a Component without harness connected (VSC Off Switch) *b No Pin Standard Resistance: Tester Connection Switch Condition Specified Condition 6 - 9 Pressed Below 1 Ω Not pressed 10 kΩ or higher If the value is not as specified, replace the VSC off switch.

1. REMOVE ROOF CONSOLE BOX ASSEMBLY

(See page )

2. REMOVE VSC OFF SWITCH

(a) Disconnect the VSC off switch connector.

(b) Disengage the 2 claws and remove the VSC off switch from the roof console box assembly.

1. INSTALL VSC OFF SWITCH

(a) Engage the 2 claws to install the VSC off switch into the roof console box assembly.

(b) Connect the VSC off switch connector.

2. INSTALL ROOF CONSOLE BOX ASSEMBLY

(See page )