Audio, Visual, Telematics
Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)
In this manual: Audio, Visual, Telematics
~1min read
DESCRIPTIONThis DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH. HINT: This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.
PROCEDURE
(a) Change the blind spot monitor sensor RH to Test Mode using the Techstream. HINT: Refer to Blind Spot Monitor Beam Axis Inspection (See page
|
Was this page helpful?