The skid control ECU (brake actuator assembly) sends signals to the millimeter wave radar sensor assembly according to the brake control status. If the millimeter wave radar sensor assembly receives a vehicle stability control system malfunction signal from the skid control ECU (brake actuator assembly), it will store DTC C1A64.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1A69
Brake Control Signal Mismatch
While the ignition switch is ON, the millimeter wave radar sensor assembly receives a vehicle stability control system malfunction signal from the skid control ECU (brake actuator assembly) for 1 second or more.
Vehicle stability control system
Millimeter wave radar sensor assembly
NOTICE:
When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle. As a result, a DTC may be stored.
If the millimeter wave radar sensor assembly has been replaced, be sure to perform millimeter wave radar sensor assembly adjustment.
Click here
The pre-collision system uses the CAN communication system. First, confirm that there are no malfunctions in the CAN communication system. Refer to How to Proceed with Troubleshooting.
Click here
PROCEDURE
CHECK FOR DTCs (VEHICLE STABILITY CONTROL SYSTEM)
HINT:
Pre-collision system DTC C1A69 may be stored due to a malfunction in the vehicle stability control system. Therefore, it is necessary to check for and troubleshoot vehicle stability control system DTCs first.
(a) Check for DTCs.
Click here
Result
Proceed to
Vehicle stability control system DTCs are not output
A
Vehicle stability control system DTCs are output
B
B
GO TO VEHICLE STABILITY CONTROL SYSTEM
A
CHECK FOR DTCs (PRE-COLLISION SYSTEM)
(a) Clear the DTCs.
Click here
(b) Make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the system cannot detect the malfunction.