(a) If the pre-collision system is not functioning properly, the driver is warned by the PCS warning light and a warning message displayed on the multi-information display.
Master Warning Indicator
Warning Message
Detail
DTC
PCS warning light
Illuminated
"Pre-Collision System Malfunction Visit Your Dealer"
Pre-collision system malfunctioning
Stored
Blinks
Trailer brake control system malfunction
Not stored
Not illuminated
"Pre-Collision System Unavailable"
Millimeter wave radar sensor assembly misaligned
Millimeter wave radar sensor assembly temperature malfunction
Millimeter wave radar sensor assembly low voltage malfunction
Trailer brake control system malfunction
Not stored
Illuminates
Not illuminated
"Pre-Collision System Unavailable Clean Sensor"
Foreign matter attached to millimeter wave radar sensor assembly
Not stored
Illuminates
Not illuminated
"Front Camera Unavailable"
Abnormal forward recognition camera voltage
Forward recognition camera temperature outside of operational range
Not stored
Illuminates
Not illuminated
"Front Camera Unavailable Remove Debris On Windshield"
The forward recognition camera or windshield glass within the field of view of the forward recognition camera is dirty or fogged up
Not stored
Illuminates
Not illuminated
"VSC Turned Off Pre-Collision Brake System Unavailable"
VSC system is disabled
Not stored
Illuminates
PCS Warning Light Illumination Status
PCS Warning Light
Condition
Blinks
ON: 0.5 sec./OFF: 1.5 sec.
Pre-collision system malfunctioning (DTC stored)
Trailer brake control system malfunctioning
Illuminates
Pre-collision system temporarily disabled
Pre-collision system disabled
VSC system disabled
Not illuminated
Other
INITIAL CHECK
(a) An initial check is performed when the ignition switch is off for more than 2 seconds and then turned to ON. The initial check consists of a pre-collision system diagnostic check with a duration of approximately 3 seconds.
(b) If a malfunction is detected during the initial check, the PCS warning light in the combination meter assembly will blink or illuminates and a warning message indicating the pre-collision system is malfunctioning or disabled will be displayed on the multi-information display.
CONSTANT CHECK
(a) The millimeter wave radar sensor assembly constantly monitors the pre-collision system for malfunctions after the ignition switch is turned to ON and the initial check (approximately 3 seconds) has completed.
(b) If a malfunction is detected during the constant check, the PCS warning light in the combination meter assembly will blink or illuminates and a warning message indicating the pre-collision system is malfunctioning or disabled will be displayed on the multi-information display.