The skid control ECU (brake actuator assembly) sends a stop light operation request signal to the stop light relay (stop light switch assembly). If the skid control ECU (brake actuator assembly) detects a malfunction in the stop light relay circuit, the millimeter wave radar sensor assembly stores DTC C1A4B.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1A4B
Stop Light Relay Circuit
While the ignition switch is ON, the millimeter wave radar sensor assembly receives a stop light relay circuit malfunction signal from the skid control ECU (brake actuator assembly) for 1 second or more.
Vehicle stability control system
Millimeter wave radar sensor assembly
NOTICE:
When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle. As a result, a DTC may be stored.
If the millimeter wave radar sensor assembly has been replaced, be sure to perform millimeter wave radar sensor assembly adjustment.
Click here
The pre-collision system uses the CAN communication system. First, confirm that there are no malfunctions in the CAN communication system. Refer to How to Proceed with Troubleshooting.
Click here
PROCEDURE
CHECK FOR DTCs (VEHICLE STABILITY CONTROL SYSTEM)
HINT:
Pre-collision system DTC C1A4B may be stored due to a malfunction in the vehicle stability control system. Therefore, it is necessary to check for and troubleshoot vehicle stability control system DTCs first.
(a) Check for DTCs.
Click here
Result
Proceed to
Vehicle stability control system DTCs are not output
A
Vehicle stability control system DTCs are output
B
B
GO TO VEHICLE STABILITY CONTROL SYSTEM
A
CHECK FOR DTCs (PRE-COLLISION SYSTEM)
(a) Clear the DTCs.
Click here
(b) Make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the system cannot detect the malfunction.