The IG circuit is the power source for the tire pressure warning ECU and receiver.
WIRING DIAGRAM
NOTICE:
When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
It is necessary to perform initialization after registration of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.
HINT:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU AND RECEIVER POWER SOURCE)
(a) Disconnect the P21 tire pressure warning ECU and receiver connector.
*a
Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Condition
Specified Condition
P21-1 (IG) - Body ground
Ignition switch ON
11 to 14 V
Ignition switch OFF
Below 1 V
(c) Measure the resistance according to the value(s) in the table below.