Tire Pressure Monitor ECU Communication Stop (C2179/79)
In this manual: Engine, Hybrid System
~2min read
DESCRIPTION
The main body ECU (multiplex network body ECU) sends signals to the tire pressure warning ECU and receiver via a direct line.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
Note
C2179/79
Tire Pressure Monitor ECU Communication Stop
Communication between the main body ECU (multiplex network body ECU) and tire pressure warning ECU and receiver is interrupted for 10 seconds or more.
Main body ECU (Multiplex network body ECU)
Wire harness or connector
Tire pressure warning ECU and receiver
-
WIRING DIAGRAM
NOTICE:
When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
It is necessary to perform initialization after registration of the transmitter IDs into the tire pressure warning ECU and receiver after the ECU has been replaced.
PROCEDURE
CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU AND RECEIVER - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))
(a) Disconnect the P21 tire pressure warning ECU and receiver connector.
(b) Disconnect the J165 main body ECU (multiplex network body ECU) connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
P21-5 (PRG) - J165-5 (PRG)
Always
Below 1 Ω
P21-5 (PRG) or J165-5 (PRG) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER
(a) Replace the tire pressure warning ECU and receiver.
Click here
NEXT
CHECK DTC OUTPUT
(a) Clear the DTCs.
Click here
(b) Turn the ignition switch off.
(c) Turn the ignition switch to ON.
(d) Check for DTCs.
Click here
OK:
DTC C2179/79 is not output.
OK
END
NG
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)