Tire Pressure Monitor Receiver Communication Stop (B1247)
In this manual: Engine, Hybrid System
~2min read
DESCRIPTION
The main body ECU (multiplex network body ECU) and tire pressure warning ECU and receiver are connected using 2 direct lines that they use to communicate with each other.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
Note
B1247
Tire Pressure Monitor Receiver Communication Stop
In diagnostic mode, an applicable RDA signal cannot be received within 10 seconds after a PRG signal is sent from the main body ECU (multiplex network body ECU).
Tire pressure warning ECU and receiver
Wire harness or connector
Main body ECU (multiplex network body ECU)
This DTC is for main body ECU (multiplex network body ECU)
WIRING DIAGRAM
NOTICE:
When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
It is necessary to perform initialization after registration of the transmitter IDs into the tire pressure warning ECU and receiver after the ECU has been replaced.
HINT:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) - TIRE PRESSURE WARNING ECU AND RECEIVER)
(a) Disconnect the P21 tire pressure warning ECU and receiver connector.
(b) Disconnect the J165 main body ECU (multiplex network body ECU) connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
P21-4 (RDA) - J165-4 (RDA)
Always
Below 1 Ω
P21-4 (RDA) or J165-4 (RDA) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
CHECK HARNESS AND CONNECTOR (POWER SOURCE OF TIRE PRESSURE WARNING ECU AND RECEIVER)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
P21-12 (GND) - Body ground
Always
Below 1 Ω
*a
Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Condition
Specified Condition
P21-1 (IG) - Body ground
Ignition switch ON
11 to 14 V
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER
(a) Replace the tire pressure warning ECU and receiver.
Click here
NEXT
CHECK DTC OUTPUT
(a) Clear the DTCs.
Click here
(b) Turn the ignition switch off.
(c) Turn the ignition switch to ON.
(d) Check for DTCs.
Click here
OK:
DTC B1247 is not output.
OK
END
NG
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)