Vehicle Interior
Inspection
INSPECTION
PROCEDURE
1. INSPECT DECK LIGHT SWITCH ASSEMBLY
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Switch Condition | Specified Condition |
5 (CCTY) - 9 (CGON) |
Cargo light switch ON |
Below 1 Ω |
Cargo light switch DOOR |
Cargo light switch OFF |
10 kΩ or higher |
10 (CGLP) - 7 (E) |
Cargo light switch ON |
Below 1 Ω |
Cargo light switch DOOR |
10 kΩ or higher |
Cargo light switch OFF |
If the result is not as specified, replace the deck light switch assembly. Text in Illustration
*a |
Component without harness connected
(Deck Light Switch Assembly) |
(b) Check the illumination.
(1) Apply battery voltage to the connector and check the illumination condition.
OK:
Measurement Condition | Specified Condition |
Battery positive (+) → Terminal 1 (ILL+)
Battery negative (-) → Terminal 4 (ILL-) |
Illuminates |
If the result is not as specified, replace the deck light switch assembly. Text in Illustration
*a |
Component without harness connected
(Deck Light Switch Assembly) |
|
 |
|
Was this page helpful?