Vehicle Interior
Inspection
INSPECTION
PROCEDURE
1. INSPECT HEADLIGHT LEVELING SWITCH
(a) Check the voltage.
(1) Connect the battery positive (+) lead to terminal 1 (B) and the negative (-) lead to terminal 5 (E).
(2) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Switch Condition | Specified Condition |
1 (B) - 2 (T) |
0 |
10.4 to 11.2 V |
1 |
8.52 to 9.24 V |
2 |
6.6 to 7.32 V |
3 |
4.68 to 5.40 V |
4 |
2.76 to 3.48 V |
5 |
0.84 to 1.56 V |
If the result is not as specified, replace the headlight leveling switch. Text in Illustration
*a |
Component without harness connected
(Headlight Leveling Switch) |
(b) Check the illumination.
(1) Apply battery voltage to the connector and check the illumination condition.
OK:
Measurement Condition | Specified Condition |
Battery positive (+) → Terminal 3 (ILL+)
Battery negative (-) → Terminal 4 (ILL-) |
Illuminates |
If the result is not as specified, replace the headlight leveling switch. Text in Illustration
*a |
Component without harness connected
(Headlight Leveling Switch) |
|
 |
|
Was this page helpful?