Vehicle Interior
Inspection
INSPECTION
PROCEDURE
1. INSPECT AUTO HIGH BEAM SWITCH
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Switch Condition | Specified Condition |
| If the result is not as specified, replace the auto high beam switch. |
6(+B) - (E) |
Auto high beam switch ON |
Below 1 Ω |
Auto high beam switch OFF |
10 kΩ or higher |
Text in Illustration
*a |
Component without harness connected
(Auto High Beam Switch) |
(b) Check the illumination.
(1) Apply battery voltage to the connector and check the illumination condition.
OK:
Battery Connection | Specified Condition |
| If the result is not as specified, replace the auto high beam switch. |
Positive (+) → 5(ILL+)
Negative (-) → 4(ILL-) |
Illuminates |
Text in Illustration
*a |
Component without harness connected
(Auto High Beam Switch) |
|
 |
|
Was this page helpful?