Vehicle Interior

Installation

~1min read

INSTALLATION

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure listed below is for the LH side.
  • A bolt without a torque specification is shown in the standard bolt chart (See page ).

PROCEDURE

1. INSTALL REAR COMBINATION LIGHT GUIDE

HINT:

  • If the rear combination light assembly LH is removed, replace the rear combination light guide.
  • Use the same procedure for both rear combination light guides.

(a) Attach the 2 claws to install a new rear combination light guide.

2. INSTALL REAR COMBINATION LIGHT ASSEMBLY LH

(a) Put protective tape around the rear combination light assembly LH.

(b) Connect each connector.

(c) Attach the 2 clips to install the rear combination light assembly LH.

(d) Using a T30 "TORX" socket wrench, install the 2 screws.

Text in Illustration

*1

Protective Tape

-

-