Engine, Hybrid System
Installation
Tightening torque found on this page
INSTALLATION
PROCEDURE
1. INSTALL AIR SWITCHING VALVE ASSEMBLY
(a) Install a new gasket and the air switching valve assembly with the 3 bolts.
Torque:
24 N·m {245 kgf·cm, 18 ft·lbf} Text in Illustration
*1 |
Air Switching Valve Assembly |
*2 |
No. 3 Air Tube |
*a |
Claw |
NOTICE:
Make sure the gasket's claws are not caught between the air switching valve assembly and No. 3 air tube. |
 |
(b) Install the 2 bolts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf} |
 |
(c) Attach the wire harness clamp to the air switching valve assembly and connect the air switching valve assembly connector.
2. CONNECT NO. 1 AIR HOSE
(a) Align the paint mark with the projection and connect the No. 1 air hose, and slide the clamp to secure the hose. Text in Illustration
*a |
Paint Mark |
*b |
Projection |
HINT:
Make sure the direction of the hose clamp is as shown in the illustration. |
 |
3. CONNECT NO. 3 VENTILATION HOSE
(a) Connect the No. 3 ventilation hose, and slide the clamp to secure the hose. Text in Illustration
*a |
Front |
*b |
Rear |
*c |
Paint Mark |
HINT:
The direction of the hose clamp is indicated in the illustration. |
 |
4. INSTALL AIR CLEANER HOSE ASSEMBLY
5. INSTALL V-BANK COVER SUB-ASSEMBLY
 |
Was this page helpful?