Vehicle Interior
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY, MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
(a) Remove the main body ECU (multiplex network body ECU) from the driver side junction block assembly.
Click here 
(b) Connect the driver side junction block assembly connectors.
(c) Measure the voltage and resistance according to the value(s) in the table below.
Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
A-32 (IG) - Body ground |
None - Body ground |
Ignition power supply |
Ignition switch ON |
11 to 14 V |
Ignition switch off |
Below 1 V |
A-31 (BECU) - Body ground |
None - Body ground |
Battery power supply |
Always |
11 to 14 V |
A-30 (ACC) - Body ground |
None - Body ground |
ACC power supply |
Ignition switch ACC |
11 to 14 V |
Ignition switch off |
Below 1 V |
A-11 (GND1) - Body ground |
None - Body ground |
Ground |
Always |
Below 1 Ω |
(d) Install the main body ECU (multiplex network body ECU) to the driver side junction block assembly.
Click here 
(e) Measure the voltage and check for pulses according to the value(s) in the table below.
Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
3J-41 (KSW) - Body ground |
G - Body ground |
Unlock warning switch assembly signal |
No key in ignition key cylinder |
11 to 14 V |
Key in ignition key cylinder |
Below 1 V |
J165-6 (FLCY) - Body ground |
GR - Body ground |
Front door courtesy light switch LH input |
Front door LH open |
Below 1 V |
Front door LH closed |
Pulse generation |
|
Was this page helpful?