Toyota Venza Quiz
Cruise Control

Cruise Control Input Circuit (P0575)

In this manual: Cruise Control
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
DESCRIPTION

This DTC indicates the internal abnormalities of the ECM.

DTC

DTC Detection Condition

Trouble Area

P0575

When both of the following conditions are met:

  • STP signals input to the ECM supervisory CPU and control ECU are different for 0.15 seconds or more
  • 0.4 seconds have passed after cruise cancel input signal (STP input) is input to the ECM

ECM

HINT:

The ECM receives signals from each sensor to control all functions of the cruise control system. When a trouble code is detected, the fail-safe function activates and remains on until the ignition switch is turned off.

PROCEDURE

  1. READ OUTPUT DTC (P0575)

(a) Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

(b) Connect the cable to the negative (-) battery terminal.

(c) Connect the Techstream to the DLC3.

(d) Turn the ignition switch to ON.

(e) Turn the Techstream on.

(f) Enter the following menus: Powertrain / Cruise Control / DTC.

(g) Read the DTCs.

Result

Proceed to

DTC P0575 is not output

A

DTC P0575 is output (for 1AR-FE)

B

DTC P0575 is output (for 2GR-FE)

C

A

USE SIMULATION METHOD TO CHECK

B

REPLACE ECM

C

REPLACE ECM

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.