Toyota Venza Quiz
Cruise Control

Fail-safe Chart

In this manual: Cruise Control
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
FAIL-SAFE CHART

HINT:

If the following conditions are detected while the cruise control is in operation, the system clears the stored vehicle speed in the ECM and cancels the cruise control operation.

Vehicle Condition

Auto Cancel Condition

Re-operation Condition

CRUISE main indicator light blinks
  • There is an open or short in the stop light switch assembly circuit
  • There is a problem with the vehicle speed signal

Turn cruise control main switch on again

CRUISE main indicator light blinks
  • There is a problem with the input circuit of the stop light switch assembly
  • There is a problem with the cancel circuit
  • Turn ignition switch off then on again
  • Turn cruise control main switch on again

CRUISE main indicator light goes off

There is a problem with the throttle position sensor and motor (throttle with motor body assembly)

Turn cruise control main switch on again

CRUISE main indicator light remains on

Under the following conditions, the stored vehicle speed is maintained:

  • Vehicle speed is lower than the low speed limit (approximately 40 km/h) while the vehicle is driven with the cruise control on
  • VSC system operates

Push cruise control main switch to + RES

Vehicle speed is lower than the stored speed by approximately 16 km/h or more

Push cruise control main switch to - SET

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.