Cruise Control Main Switch
Removal REMOVAL PROCEDURE
1. REMOVE STEERING PAD
(See page .gif)
)
2. REMOVE CRUISE CONTROL MAIN SWITCH
(a) Remove the 2 screws. |
 |
(b) Disconnect the connector and remove the cruise control main switch shown in the illustration. |
 |
1. INSPECT CRUISE CONTROL MAIN SWITCH
(a) for vehicles without vehicle-to-vehicle distance control mode:
(1) Measure the resistance according to the value(s) in the table below.
Text in Illustration *1 |
Component without harness connected: (Cruise Control Main Switch) |
*2 |
Main Switch |
*3 |
Lever |
*4 |
ON/OFF |
*5 |
- SET |
*6 |
+ RES |
*7 |
CANCEL |
- |
- |
Standard Resistance:
Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
1 (ECC) - 3 (CCS) |
Main Switch off*1 |
1 MΩ or higher |
Main Switch on |
Below 2.5 Ω |
|
+ RES |
235 to 245 Ω |
|
- SET |
617 to 643 Ω |
|
CANCEL |
1509 to 1571 Ω |
*1: Lever is in neutral position
If the result is not as specified, replace the cruise control main switch.
Installation INSTALLATION PROCEDURE1. INSTALL CRUISE CONTROL MAIN SWITCH
(a) Connect the connector.
(b) Install the cruise control main switch with the 2 screws shown in the illustration. Torque: 2,4 N·m {24 kgf·cm, 21 in·lbf} |
 |
2. INSTALL STEERING PAD
(See page .gif)
)
Test yourself
A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.