Installation

HINT:

• Use the same procedure for the RH side and LH side.
• The following procedure is for the LH side.
• The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.
• If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

(a) Install the rear axle hub and bearing assembly (See page ).

HINT:

• The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.
• If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.

2. INSPECT REAR AXLE HUB BEARING LOOSENESS

3. INSPECT REAR AXLE HUB RUNOUT

4. INSTALL REAR DISC

5. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

6. INSTALL REAR FLEXIBLE HOSE

7. INSTALL REAR SPEED SENSOR WIRE

(a) Connect the connector to the rear speed sensor.

8. INSTALL REAR WHEEL

Torque:

103 N·m {1050 kgf·cm, 76 ft·lbf}

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

10. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

HINT:

(See page ).

11. CHECK FOR SPEED SENSOR SIGNAL

HINT:

(See page ).