Toyota Venza Quiz
Window / Glass

Removal

In this manual: Window / Glass
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
REMOVAL CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The procedure listed below is for the LH side.
PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system (See page ).


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).


2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG


3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL


4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


5. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY


6. REMOVE REAR DOOR SERVICE HOLE COVER


7. REMOVE REAR DOOR GLASS RUN


8. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY


9. REMOVE REAR DOOR GLASS SUB-ASSEMBLY


10. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY


11. REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Using a T25 "TORX" driver, remove the 3 screws and the rear power window regulator motor assembly.

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.