Toyota Venza Quiz
Wiper / Washer

Removal

In this manual: Wiper / Washer
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
REMOVAL PROCEDURE

1. REMOVE FRONT DOOR SCUFF PLATE LH


2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH


3. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL


4. REMOVE LOWER STEERING COLUMN COVER

(a) Turn the steering wheel assembly to the right and remove the screw shown in the illustration.

(b) Turn the steering wheel assembly to the left and remove the screw shown in the illustration.

(c) Disengage the 3 claws and remove the lower steering column cover.

5. REMOVE UPPER STEERING COLUMN COVER

(a) Disengage the 4 clips and 3 claws and remove the upper steering column cover.

6. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

(a) Disconnect the 2 connectors.

(b) Disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.

NOTICE:

If the claw is pushed with excessive force, it may break.

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.