Removal

HINT:

• Use the same procedure for the LH side and RH side.
• The following procedure is for the LH side.
• If the sensor rotor needs to be replaced, replace it together with the rear drive shaft assembly.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE REAR WHEEL

3. REMOVE REAR DOOR SCUFF PLATE LH

4. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

5. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

6. REMOVE DECK BOARD ASSEMBLY

7. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY

8. REMOVE DECK SIDE TRIM BOX LH

9. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY

10. REMOVE DECK SIDE TRIM BOX RH

11. REMOVE NO. 1 DECK BOARD

12. REMOVE REAR SEAT SUB FLOOR PANEL ASSEMBLY

13. REMOVE REAR FLOOR FINISH PLATE

14. REMOVE RECLINING REMOTE CONTROL BEZEL LH

15. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY

16. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY LH

17. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

18. REMOVE REAR SPEED SENSOR

(a) Disconnect the rear speed sensor connector. Text in Illustration *1 Grommet

(b) Disconnect the grommet of the rear speed sensor wire from the hole of the wheel house. Text in Illustration *1 No. 2 Clamp *2 No. 1 Clamp

(c) Remove the 2 bolts, No. 1 clamp and No. 2 clamp from the body and absorber.

(d) Remove the bolt and rear speed sensor from the carrier. NOTICE: Keep the sensor tip and rear speed sensor installation hole free from foreign matter.