Installation

HINT:

• Use the same procedure for the LH side and RH side.
• The following procedure is for the LH side.
• If the sensor rotor needs to be replaced, replace it together with the rear drive shaft assembly.

1. INSTALL REAR SPEED SENSOR

(a) Install the rear speed sensor with the bolt. Torque: 8,5 N·m {87 kgf·cm, 75 in·lbf} NOTICE: Keep the rear speed sensor tip and sensor installation hole free from foreign matter.

(b) Install the No. 1 clamp and No. 2 clamp with the 2 bolts. Torque: 8 N·m {82 kgf·cm, 71 in·lbf} NOTICE: Do not twist the rear speed sensor wire when installing the clamps. Text in Illustration *1 No. 2 Clamp *2 No. 1 Clamp

(c) Insert the connector and grommet to the inside of the vehicle through the passage hole in the wheel well.

NOTICE:

Make sure that the grommet's band clamp remains on the outside of the vehicle.

(d) Hold the grommet and pull it from the inside to the outside of the vehicle. Then secure it in place so that it is not tilted.

NOTICE:

When pulling out the grommet, do not grip the sensor wire.

(e) Connect the rear speed sensor connector. Text in Illustration *1 Grommet

2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

3. CONNECT REAR SEAT OUTER BELT ASSEMBLY LH

4. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY

5. INSTALL RECLINING REMOTE CONTROL BEZEL LH

6. INSTALL REAR FLOOR FINISH PLATE

7. INSTALL REAR SEAT SUB FLOOR PANEL ASSEMBLY

8. INSTALL NO. 1 DECK BOARD

9. INSTALL DECK SIDE TRIM BOX RH

10. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY

11. INSTALL DECK SIDE TRIM BOX LH

12. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY

13. INSTALL DECK BOARD ASSEMBLY

14. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

15. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

16. INSTALL REAR DOOR SCUFF PLATE LH

17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

18. CHECK FOR SPEED SENSOR SIGNAL

HINT:

(See page ).