Toyota Venza Quiz
Axle And Differential

Removal

In this manual: Axle And Differential
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
REMOVAL CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The procedure listed below is for the LH side.
PROCEDURE

1. REMOVE REAR WHEEL

2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY


3. REMOVE REAR DISC


4. SEPARATE REAR SPEED SENSOR WIRE


5. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY


6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


7. REMOVE REAR STRUT ROD ASSEMBLY


8. REMOVE REAR AXLE CARRIER SUB-ASSEMBLY

(a) Loosen the 2 bolts.

NOTICE:

Since stopper nuts are used, loosen the bolts.

(b) Remove the 2 bolts and 2 nuts, and separate the rear axle carrier sub-assembly from the rear shock absorber with coil spring.

NOTICE:

When removing the nuts, keep the bolts from rotating.

(c) Remove the 2 bolts, 2 nuts and rear axle carrier sub-assembly.

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.