Toyota Venza Quiz
Door Lock

Transmitter Battery(w/o Smart Key System)

In this manual: Door Lock
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~2min read
Replacement REPLACEMENT PROCEDURE

1. REMOVE TRANSMITTER HOUSING COVER

(a) Using a precision screwdriver with its tip wrapped in protective tape, pry open the transmitter housing cover.

NOTICE:

Do not forcibly pry the cover.

HINT:

Tape the screwdriver tip before use.

2. REMOVE DOOR CONTROL TRANSMITTER MODULE

(a) Using a precision screwdriver with its tip wrapped in protective tape, remove the door control transmitter module from the transmitter housing case.

NOTICE:

Handle each part with care as they are delicate electrical parts.

HINT:

Tape the screwdriver tip before use.

3. REMOVE TRANSMITTER BATTERY

(a) Twist the coin in the direction of the arrow in the illustration, and remove the transmitter battery cover.

(b) Remove the battery (lithium battery: CR2025).

NOTICE:

  • Do not push the terminals with your finger.
  • Do not forcibly pry up the battery. The terminals may be damaged.
  • Do not touch the battery with wet hands. Water may cause rust.
  • Do not touch or move any components inside the transmitter. It may interfere with proper operation.

4. INSTALL TRANSMITTER BATTERY

(a) Install a battery (lithium battery: CR2025) with the positive (+) side facing upward, as shown in the illustration.

NOTICE:

  • Be careful not to bend the transmitter battery electrode during insertion.
  • Keep the transmitter cover interior free of dust and oil.

(b) Install the cover.

5. INSTALL DOOR CONTROL TRANSMITTER MODULE

(a) Install the door control transmitter module into the transmitter housing case.

6. INSTALL TRANSMITTER HOUSING COVER

(a) Install the transmitter housing cover to the transmitter housing case.

(b) Check that the transmitter LED illuminates when the switch is pressed.

OK:

Transmitter LED illuminates when switch is pressed.

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.