Toyota Venza Quiz
Door Lock

Door Control Switch

In this manual: Door Lock
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
Components COMPONENTS ILLUSTRATION
Inspection INSPECTION PROCEDURE

1. INSPECT DOOR CONTROL SWITCH ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

4 (L) - 3 (E)

Locked

Below 1 Ω

4 (L) - 3 (E)

Off

10 kΩ or higher

2 (UL) - 3 (E)

Unlocked

Below 1 Ω

2 (UL) - 3 (E)

Off

10 kΩ or higher
Text in Illustration

*1

Component without harness connected

(Door Control Switch Assembly)

*2

Unlock

*3

Lock

If the result is not as specified, replace the door control switch assembly
Removal REMOVAL PROCEDURE

1. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL


2. REMOVE DOOR CONTROL SWITCH ASSEMBLY

(a) Disengage the 2 claws and remove the door control switch assembly.
Installation INSTALLATION PROCEDURE

1. INSTALL DOOR CONTROL SWITCH ASSEMBLY

(a) Engage the 2 claws and install the door control switch assembly.

2. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.