Toyota Venza Quiz
Theft Deterrent / Keyless Entry

Transponder Key Amplifier

In this manual: Theft Deterrent / Keyless Entry
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
Components COMPONENTS ILLUSTRATION
Removal REMOVAL PROCEDURE

1. REMOVE FRONT DOOR SCUFF PLATE


2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY


3. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL


4. REMOVE LOWER STEERING COLUMN COVER


5. REMOVE UPPER STEERING COLUMN COVER


6. REMOVE TRANSPONDER KEY AMPLIFIER

(a) Disengage the 2 claws and disconnect the transponder key amplifier as shown in the illustration.

(b) Disconnect the connector and remove the transponder key amplifier.
Installation INSTALLATION PROCEDURE

1. INSTALL TRANSPONDER KEY AMPLIFIER

(a) Connect the connector to the transponder key amplifier.

(b) Engage the 2 claws and install the transponder key amplifier.

2. INSTALL UPPER STEERING COLUMN COVER


3. INSTALL LOWER STEERING COLUMN COVER


4. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL


5. INSTALL COWL SIDE TRIM SUB-ASSEMBLY


6. INSTALL FRONT DOOR SCUFF PLATE

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.