Volkswagen Golf Quiz
4- cylinder injection engine(1.4 1 direct inction. turbocharger)

Removing and installing coolant temperature sender -G62

In this manual: 4- cylinder injection engine(1.4 1 direct inction. turbocharger)
General body repairs, exterior — 230General body repairs, interior — 279General information, paint — 133Vechile- specific paint information — 27Heating, air conditioning — 156Auxiliary heater — 58Air conditioning system with refrigerant R134a — 1297- speed dual clutch gearbox 0CW — 544- cylinder injection engine(1.4 1 direct inction. turbocharger) — 182Fuel supply system - Petrol engines — 59Running gear, axles, steering — 221Brake system — 92Wheels and Tyres guide — 12Guide for using trailers — 11Wheels and Tyres Guide - General Information — 121Brake system (hybrid) — 73Electrical system — 326Communication — 65Electrical system, general information — 111
~1min read

Removing

Engine cold
  • Briefly open cap of coolant expansion tank -arrow- in order to release residual pressure in the cooling system, then tighten the cap again until it engages.
  • Separate electrical connectors.
Note

Place a cloth underneath to catch escaping coolant.
Removing and installing coolant temperature sender -G62
  • Unscrew bolt -1- and pull off coolant temperature sender -G62--item 2-.
Note If O-ring -3- with support ring -4- remains lodged in cylinder head, lift out O-ring with support ring using a piece of wire. Insert new coolant temperature sender -G62- immediately into cylinder head in order to avoid loss of coolant.

Installing

Installation is carried out in the reverse order; note the following:

Note

Renew O-ring.

  • Check coolant level → Anchor.

Specified torques

→ Chapter „Assembly overview - coolant temperature sender“
Removing and installing coolant temperature sender -G62

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.