4- cylinder injection engine(1.4 1 direct inction. turbocharger)

Removing and installing charge air cooling pump -V188-

~1min read

Special tools and workshop equipment required

Hose clamps up to 25 mm -3094-

Removing and installing charge air cooling pump -V188-

Drip tray for workshop hoist -VAS 6208-

Removing and installing charge air cooling pump -V188-

Hose clip pliers -VAS 6362-

Removing

Removing and installing charge air cooling pump -V188-
  • Open cap -arrow- on coolant expansion tank.
The cooling system is under pressure when the engine is hot. Hot steam/hot coolant can escape - risk of scalding. Risk of scalding to skin and body parts.Wear protective gloves.Wear eye protection.Release pressure by covering cap of coolant expansion tank with a cloth and opening it carefully.
  • Remove noise insulation → General body repairs, exterior; Rep. gr.66.
Removing and installing charge air cooling pump -V188-
  • Disconnect electrical connector -1-.
  • Set drip tray for workshop hoist -VAS 6208- underneath.
  • Clamp off coolant hoses on charge air cooling pump -V188- using hose clamps up to 25 mm -3094-.
  • Release hose clips -3- and detach coolant hoses.
  • Unscrew bolt -2- and remove charge air cooling pump -V188-.

Installing

Installation is carried out in the reverse order; note the following:

Note Secure all hose connections with the same type of hose clips as original equipment → Electronic Parts Catalogue.
  • Install noise insulation → General body repairs, exterior; Rep. gr.66.
  • Check coolant level → Anchor.

Specified torques

→ Chapter „Assembly overview - electric coolant pump“

Removing and installing charge air cooling pump -V188-

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.