Volkswagen Golf Quiz
4- cylinder injection engine(1.4 1 direct inction. turbocharger)

Removing and installing coolant temperature sender at radiator outlet -G83

In this manual: 4- cylinder injection engine(1.4 1 direct inction. turbocharger)
General body repairs, exterior — 230General body repairs, interior — 279General information, paint — 133Vechile- specific paint information — 27Heating, air conditioning — 156Auxiliary heater — 58Air conditioning system with refrigerant R134a — 1297- speed dual clutch gearbox 0CW — 544- cylinder injection engine(1.4 1 direct inction. turbocharger) — 182Fuel supply system - Petrol engines — 59Running gear, axles, steering — 221Brake system — 92Wheels and Tyres guide — 12Guide for using trailers — 11Wheels and Tyres Guide - General Information — 121Brake system (hybrid) — 73Electrical system — 326Communication — 65Electrical system, general information — 111
~1min read

Removing

Engine cold
  • Briefly open cap of coolant expansion tank -arrow- in order to release residual pressure in the cooling system, then tighten the cap again until it engages.
  • Remove noise insulation → General body repairs, exterior; Rep. gr.66.
Removing and installing coolant temperature sender at radiator outlet -G83
  • Disconnect electrical connector -2-.
Note

Place a cloth underneath to catch escaping coolant.

  • Pull off retaining clip -1- and pull radiator outlet coolant temperature sender -G83- out of connection -3-.

Installing

Installation is carried out in the reverse order; note the following:

Note

Renew O-ring.

Insert new coolant temperature sender -G62- immediately into connection in order to avoid loss of coolant.
  • Install front noise insulation → General body repairs, exterior; Rep. gr.66.
  • Check coolant level → Anchor.
Removing and installing coolant temperature sender at radiator outlet -G83

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.